Peripheral ports
The section below describes different peripheral ports and power present on the device.
Top - Power
The SIA module has three pluggable block terminals located on the top side of the enclosure. They are the RS232 and RS485 interfaces along with a DC power input. The power connections are highlighted and numbered in the picture below. For the serial connections please refer to the serial connection page
| Terminal number | Description |
|---|---|
| 1 | ~24VDC |
| 2 | Ground |
Bottom - Ethernet & USB
The bottom side of the enclosure contains 2x 10/100M ethernet ports. Port X1 is the primary port used for the initial setup of the device and is configured with a default IP address 10.20.30.40
The illustration below shows the bottom side of the device with an optional USB port added on.
On the Plus version (SIA Connect Standalone Plus) the Ethernet ports are both 1G
Powering up
To power SIA on, use screw terminals to mount power and ground connections. After the wires have been fastened in place, the power status LED should be turned on indicating present operating voltage.
In case a hard restart of the device is needed, this terminal can be simply plugged out and reinserted back in without manipulating the wire screw connections.
Status LEDs description
The table below describes the operation and functionality of the status LEDs located on the front side of the enclosure.
| Name | Operation | Description | LED Color |
Power |
Static ON | Operating voltage is present |  |
| Static OFF | The device is powered off | ||
Status |
Slow blink | The system has encountered an error but is recovered |  |
| Fast blink | Initialization state |  |
|
| RS232 RX | Flashing | RS232 data received |  |
| RS232 TX | Flashing | RS232 data transmitted | |
| RS485 RX | Flashing | RS485 data received | |
| RS485 TX | Flashing | RS485 data transmitted |